Schick USBCam2 Guide de l'utilisateur télécharger pdf (Page 24)

B1051061 Rev. – USBCam2 User Guide

4. Operation

4.1. Operating the Camera

Refer to the following sections for instructions on turning the USBCam2 on and off and

taking still images from streaming live video ("freeze-frame" capture).

4.1.1. Turning the Camera On

Before turning on the camera make sure the cable connections are secured. Turn on the

camera by clicking the Power On/Off button (Figure 1, item 2). Removing the handpiece

from its holder also turns the camera on.

4.1.2. Turning the Camera Off

When the camera's light is on, clicking the camera’s Power On/Off button (

Figure 1, item

2) shuts power off to the camera. Clicking the Power On/Off button restores power to

camera and turns the LEDs back on.

When not in use, store the camera in its holder to protect the device and for easy access.

Placing the camera in its holder turns off the camera automatically.

NOTE: Camera will turn off automatically after 5 minutes of continuous use.

4.1.3. Pausing and Capturing Still Frame Images

NOTE: The following steps apply to the use of USBCam2 with CDR DICOM software.

To set up your handpiece Freeze Frame button for Freeze/Take mode, do the following:

• Click the Setup button on the Video Capture window

• Select the option for Freeze/Take

• Click OK to save settings

To use your handpiece in this mode, depress the Freeze Frame button once (Figure 1, item

3) to capture the frame. To resume live video after taking an image, select any empty

viewbox and click on it.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Pas de commentaire

Schick USBCam2 Guide de l'utilisateur Page 24